Noticia

Metal Pails Product Knowledge

Metal Pails product knowledge

Knowledge of paint buckets: If you choose inner iron phosphating or no inner coating Metal Pailss, you need to use them up within 15 days. If the time exceeds 15 days, the inner phosphating film may be corroded.

Knowledge of galvanized drums: If the user contains liquid, it should be calculated according to the specific gravity of the product, but there must be enough space for the product to crack 10 percent due to thermal expansion (but for low boiling point products), to prevent the Metal Pails from cracking when it is dropped and deformed. If the user packs products with low boiling point (generally referring to boiling point below 60 degree ), it is necessary to fully consider that such products have vapor pressure at a certain temperature, and the vapor pressure of liquid increases with the increase of temperature. In addition, it is necessary to consider the temperature difference between the maximum storage and transportation temperature (up to 60 degrees, such as the equator) that the Metal Pails may encounter after the product is filled, which will cause the product to expand in volume and cause internal pressure in the Metal Pails. The sum of these two pressures cannot be greater than the allowable internal pressure of the Metal Pails, otherwise the Metal Pails will burst.

Knowledge of inner coating bucket: If the user of inner coating, we can provide the sample of inner coating, conduct immersion test under the required temperature and conditions, analyze whether the coating changes, and then determine the inner coating. All kinds of inner-coated Metal Pailss are not suitable for products that are liquid during filling and become solid after being filled with temperature.

Knowledge of steel-plastic composite plastic liner barrel: Since the lining of the steel-plastic composite barrel is polyethylene, it is not suitable for filling products above 55 degree , or products that need to be heated above 55 degree during use, so as to avoid damage to the steel barrel.

Knowledge of plastic barrels: Polyethylene is sequentially blow-molded and can be used for hot filling. The general temperature should not exceed 60 degree . After hot filling, the lids and stacking should be closed after the contents are fully cooled.


También podría gustarte

Envíeconsulta